Metabolism of phospholipids in the yeast Schizosaccharomyces pombe

The fission yeast Schizosaccharomyces pombe is an important model organism for the study of fundamental questions in eukaryotic cell and molecular biology. A plethora of cellular processes are membrane associated and/or dependent on the proper functioning of cellular membranes. Phospholipids are not only the basic building blocks of cellular membranes; they also serve as precursors to numerous signaling molecules. In this review, we describe the biosynthetic pathways leading to major S. pombe phospholipids, how these pathways are regulated, and what is known about degradation and turnover of fission yeast phospholipids. This review also addresses the synthesis, regulation and the role of water-soluble phospholipid precursors. The last chapter of the review is devoted to the use of S. pombe for the biotechnological production of value-added lipid molecules.     

基于ＰＩＤ控制算法的直流微网容错控制方法研究

构建直流微网容错控制对象模型，调节直流微电网的输出回路参数；以输出功率、直流微网的 参考电压、弱电网下系统惯性响应特征等为约束参量，构建直流微网容错控制目标函数，在不同电网强度下 进行直流微网容错控制的参数自整定性调节，采用无功环比例积分控制方法进行直流微网容错寻优分析， 建立模糊 ＰＩＤ控制模型，采用变结构的模糊 ＰＩＤ控制方法进行直流微网容错控制过程中的自适应加权学习 和误差反馈调节，实现直流微网容错控制改进设计。仿真结果表明，采用该方法进行直流微网控制的容错 性能较好，输出稳定性较强，具有较好的直流微网输出增益。     

基于永磁涡流传动的长距离带式输送机启动特性研究

针对矿用带式输送机启动过程易出现打滑、淤带和断带等问题,基于永磁涡流传动技术,将双盘式磁力耦合器作为带式输送机的驱动装置,建立双盘式磁力耦合器动态数学模型,运用AMEsim软件搭建带式输送机系统仿真模型,设置启动时间分别为60、80和100 s,采用Harrison控制曲线启动时,研究带式输送机满载启动时机头、机尾部输送带的速度特性和张力特性,张紧装置位移特性以及双盘式磁力耦合器调速气隙特性,仿真结果表明:当启动时间为60 s时,带式输送机输送带速度波动大,动张力明显,尾部输送带最大张力达到29 kN,启动过程不平稳;双盘式磁力耦合器调速时,气隙变化与带式输送机启动速度变化趋势相反,启动过程气隙从22 mm减小到4 mm;当启动时间为80 s和100 s时,带式输送机启动过程相对平稳,速度和张紧装置位移波动小,尾部输送带张力波动幅度分别为5 kN和3 kN;带式输送机启动过程存在最佳启动时间,继续延长时间,对带式输送机启动特性影响越来越小,80 s可作为合理启动时间。     

微电解Fenton法处理有机废水可行性研究

采用微电解Fenton法处理硫铵酯-苯甲羟肟酸-苯胺黑有机废水。考察了初始pH值、铁屑及活性炭投入量、曝气量、H₂O₂用量、催化剂MnO₂加入量和反应时间对废水COD、NH₃-N和色度去除率的影响。最佳条件为:初始pH=3、铁屑用量70 g/L、活性炭用量80 g/L、H₂O₂用量7 mg/L、MnO₂用量8.0 g/L、曝气量500 mL/(min·L)、反应时间20 min,此时废水COD、NH₃-N和色度的去除率达88.21%、93.57%和98.68%。通过多因素正交实验确定了影响COD、NH₃-N和色度去除率的因素强弱顺序为:铁屑投入量=活性炭投入量>H₂O₂用量>pH值>MnO₂用量。     

Optimal sizing of wind-hydrogen system considering hydrogen demand and trading modes

In order to make full use of renewable energy and improve the utilization of wind power, a new joint optimization scheme of the wind-hydrogen system coupled with transmission project is proposed in this paper, in which wind power is reasonably allocated for grid integration and for hydrogen production. Aiming at maximize the annul wind-hydrogen system benefit, the optimal sizes of wind power transmission project and hydrogen system are obtained under different hydrogen production modes, hydrogen trading modes and hydrogen demand levels. In addition, the penalty cost of wind curtailment and hydrogen supply shortage and the system environmental benefits are taken into account. Results show: during the long-term of insufficient of wind power, it is better to produce hydrogen using wind power and grid-assisted power to avoid hydrogen supply shortage; considering the future increase of hydrogen demand, the optimal supply number of hydrogen refueling stations in the wind-hydrogen system is two. Also, the low utilization of fuel cells means that the benefit from regeneration cannot offset the high cost, which leads to the abnegation of fuel cells in the wind-hydrogen system.     

Experimental study on gas–liquid dispersion and mass transfer in shear-thinning system with coaxial mixer

The effects of impeller type, stirring power, gas flow rate, and liquid concentration on the gas–liquid mixing in a shear-thinning system with a coaxial mixer were investigated by experiment, and the overall gas holdup, relative power demand, and volumetric mass transfer coefficient under different conditions were compared. The results show that, the increasing stirring power or gas flow rate is beneficial in promoting the overall gas holdup and volumetric mass transfer coefficient, while the increasing system viscosity weakens the mass transfer in a shearing–thinning system. Among the three turbines, the six curved-blade disc turbine (BDT-6) exhibits the best gas pumping capacity; the six 45° pitched-blade disc turbine (PBDT-6) has the highest volumetric mass transfer coefficient at the same unit volume power.     

钢轨交流闪光焊接过程过梁爆破特征分析

以高速摄影技术作为主要研究手段，研究钢轨交流闪光焊接过程过梁爆破特征，并结合热成像系统采集焊接过程温度场，以此为数据基础定量分析了钢轨交流闪光焊接过梁爆破特征. 结果表明,钢轨交流脉动闪光焊接工艺模式下，加速闪光阶段具有几个阶段中最高的闪光频次46.93次/s，脉动闪光阶段具有最低的闪光频次11.07次/s；连续闪光阶段闪光烈度为0.009 2 mm/次，是几个阶段中最强的，脉动阶段的闪光烈度最弱，为0.003 8 mm/次；从闪光加热因子来看，脉动阶段最高，符合了该阶段积累热量的主要目的；加速闪光阶段最低，是由于该阶段为了制造保护气氛产生的气化过梁带走了较多的热量；从闪光均匀度看，闪光最不均匀的阶段是闪平阶段，最均匀的阶段是脉动阶段，这恰恰说明了两待焊端面的微观平行情况在闪平阶段最差、脉动阶段最佳.     

天津市近代机场的规划和建设研究

分析近代天津历次近代城市规划中机场布局思想的演进历程，采用比较研究方法剖析天津近代各类机场设计方案的异同及其各自特征，并总结了天津近代机场场面规制及其跑道形制在不同时期的演进规律，还从规划编制体例角度论证了天津近代机场规划及其实例应用。     

掺铒单模光纤飞秒脉冲激光器和放大器

为了获得一种被动锁模掺铒光纤振荡器及功率放大器，数值模拟出超短脉冲在光纤中的传输和演化过程，并基于此搭建了一种被动锁模掺铒光纤飞秒振荡器及功率放大器。实验获得了中心波长1560 nm、重复频率100 MHz、输出功率30 mW、脉冲宽度85 fs超短脉冲。通过采用PPLN晶体进行倍频，进一步获得了输出功率5 mW，中心波长780 nm的飞秒脉冲。该光纤激光器为全保偏光纤结构，具有体积小巧、可靠性高、稳定性好的特点。     

Reexamination of the Ergothioneine Biosynthetic Methyltransferase EgtD from Mycobacterium tuberculosis as a Protein Kinase Substrate

Ergothioneine has emerged as a crucial cytoprotectant in the pathogenic lifestyle of Mycobacterium tuberculosis. Production of this antioxidant from primary metabolites may be regulated by phosphorylation of Thr213 in the active site of the methyltransferase EgtD. The structure of mycobacterial EgtD suggests that this post-translational modification would require a large-scale change in conformation to make the active-site residue accessible to a protein kinase. In this report, we show that, under in vitro conditions, EgtD is not a substrate of protein kinase PknD.